The secondary modulation with the NeumannHoffman code increases the possibility of bit sign transition. Unlike other GNSS signals, there is no pilot component for synchronization in BeiDou B1/B3 signals, which increases the complexity in acquisition. A previous study has shown that the delay and multiplication (DAM) method is able to eliminate the bit sign transition problem, but it only applies to pretty strong signals. In this paper, a DAM-based BeiDou signal acquisition approach, called variable length data accumulation (VLDA), is proposed to acquire weak satellite signals. Firstly, the performance of DAM method versus the different delays is analyzed. The DAM operation not only eliminates bit sign transition, but it also increases noise power. Secondly, long-term signal is periodically accumulated to improve signal intensity in order to acquire weak signals. While considering the Doppler frequency shift of ranging codes, the signal length must be compensated before accumulating long-term signal. Finally, the fast-Fourier-transform based parallel code phase algorithm are used for acquisition. The simulation results indicate that the proposed VLDA method has better acquisition sensitivity than traditional non-coherent integration method under the same calculation amount. The VLDA method only requires approximately 27.5% of calculations to achieve the same acquisition sensitivity (35 dBHz). What is more, the actual experimental results verify the feasibility of the VLDA method. It can be concluded that the proposed approach is an effective and feasible method for solving the bit sign transition problem.