




















Authors:Omar Barrera, Bryan T. Bosworth, Taran Anusorn, Kenny Huynh, Ian Anderson, Nicholas R. Jungwirth, Michael Liao, Sinwoo Cho, Jack Kramer, Lezli Matto, Mark S. Goorsky, Nathan D. Orloff, Ruochen Lu
Abstract:Compact, high-performance components in millimeter-wave (mmWave) communication systems demand new acoustic filter technology at increasingly higher frequencies. Among various promising mmWave platforms, first-order antisymmetric (A1) mode laterally excited bulk acoustic resonators (XBARs) in thin-film lithium niobate (LiNbO3) have perhaps the most impressive linear performance. Despite these advances, there are few reports of nonlinear characterization of LiNbO3 filters at mmWaves. Here, we address this gap by developing a new nonlinear methodology for high-frequency filters. The result is a methodology for performing power-dependent S-parameters and third-order intermodulation (IMD3) measurements. To test our methodology, we fabricated filters on transferred single-crystal LiNbO3 films on sapphire (Al2O3) and silicon (Si) substrates with amorphous silicon (aSi) sacrificial layer. At 21.8 GHz, the filters on Al2O3 demonstrated an insertion loss of 1.48 dB, a 3 dB fractional bandwidth (FBW) of 17.7%, and in-band third-order input intercept points (IIP3) of 50.8 dBm. At 21.6 GHz, the filters on silicon demonstrated an insertion loss of 2.47 dB, a 3 dB FBW of 18.6%, and in-band IIP3 of 46.5 dBm. The nonlinear results conclusively show that thermal stability and passband distortion improved on the Al2O3 substrate, confirming that substrate selection plays a pivotal role in mitigating nonlinearity in acoustic front-end modules.
From: Taran Anusorn [view email]
[v1]
Mon, 13 Apr 2026 16:52:48 UTC (2,716 KB)
[v2]
Fri, 3 Jul 2026 04:19:15 UTC (2,232 KB)
此内容由惯性聚合(RSS阅读器)自动聚合整理,仅供阅读参考。 原文来自 — 版权归原作者所有。