Visual Simultaneous Localization and Mapping (SLAM) plays a crucial role in autonomous systems. Traditional SLAM methods, based on static environment assumptions, struggle to handle complex dynamic environments. Recent dynamic SLAM systems employ geometric constraints and deep learning to remove dynamic features, yet this creates a new challenge: insufficient remaining point features for subsequent SLAM processes. Existing solutions address this by continuously introducing additional line and plane features to supplement point features, achieving robust tracking and pose estimation. However, current methods continuously introduce additional features regardless of necessity, causing two problems: unnecessary computational overhead and potential performance degradation from accumulated low-quality additional features and noise. To address these issues, this paper proposes a feature-aware mechanism that evaluates whether current features are adequate to determine if line feature support should be activated. This decision mechanism enables the system to introduce line features only when necessary, significantly reducing computational complexity of additional features while minimizing the introduction of low-quality features and noise. In subsequent processing, the introduced line features assist in obtaining better initial camera poses through tracking, local mapping, and loop closure, but are excluded from global optimization to avoid potential negative impacts from low-quality additional features in long-term process. Extensive experiments on TUM datasets demonstrate substantial improvements in both ATE and RPE metrics compared to ORB-SLAM3 baseline and superior performance over other dynamic SLAM and multi-feature methods.